![]() ![]() On the other side, repeat with the second half-stick. Arrange them such that the half-full stick’s hole is over the arm’s center hole. Connect the crossbow arms to the halvesĬover one of the crossbow arms with a half-stick. To ensure an equal cut, use a tiny handsaw or a serrated knife. Half-cut a Popsicle stickĬut the last popsicle stick in half lengthwise, through the center hole. These are the crossbow arms you’ll be using. Rep on the other side using a second popsicle stick. Insert a screw into one of the holes in your stick through the hole at the end of a popsicle stick. Each hole should be filled with a Popsicle stick These holes must be the same size as the screws. Place the holes 12 inch (2.5 cm) apart, in alignment with each other, from the very same short end. One hole near the opposite end and one hole in the precise center.īore two holes in the lumber near one endīore two openings in the same side of the wood without going all the way through it.Drill three holes the size of your small screws in each Popsicle stick. Take three regular Popsicle sticks, each measuring 412 inches (11.5 cm) in length. Five short screws, tiny enough to drill through a Popsicle stick, are also required. It should measure approximately 8–9 inches (20–23 cm) in length. Easy Guideline For Making a Mini Crossbow Find a stick of lumber and screwsīegin with a rectangle piece of scrap lumber that is 1″ x 2″ or smaller in size (20 x 40 mm). ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |